Page 1 INSTALLATION, OPERATION AND MAINTENANCE MANUALRefer to enclosed warranty and operating parameters to ensure proper use with your
Page 10 Connect White Tube from TANK Port on RO Module to the TankPosition tank in desired location. Stand it upright or lay it on it
Page 11 3/8” Black Tube Connection from FaucetMeasure the black tube from faucet to the black drain saddle and make a straight cut thro
Page 12 Connect the Blue Tube from the Faucet to RO ModuleStep 26Step 25Connect the Red Tube from Faucet to RO Modulea) Insert the fl o
Page 13 The following steps should be followed to change the cartridges. Orient the cartridge with the label facing to the left (9 o’
Page 14 Turn off the incoming water supply at the adapta valve.Open the faucet, allow the tank to empty, and then close the faucet.Rem
Page 15 Turn off the incoming water supply at the adapta valve.Open the faucet, allow the tank to empty, and then close the faucetCheck
Page 16 TROUBLE SHOOTINGProblem Cause Solution1. Low/Slow Production Low Water Pressure Assure a minimum of 40 psi incoming
Page 17 Service RecordDate of Purchase:__________ Date of Install:___________ Installed by:__________________ Serial No. ___________
Page 18 Limited WarrantyThis Reverse Osmosis System is warranted against defects in material and workmanship for a period of one year f
Page 19 ITEM QTY PART # DESCRIPTION1 1 WQCS-10,11,13” SEDIMENT FILTER2 1 WQCC-10,11,13” PRE-CARBON FILTER3 1 WQCM-10,11,13” MEMBRANE FI
Page 2 Thank you for your purchase of a state of the art Watts Reverse Osmosis (RO) water treatment system. Water quality concerns are
Page 20
Page 3 With proper installation and maintenance, this system will provide you with high quality water for years to come. All of Watts
Page 4 Hardness: Recommended hardness should not exceed 10 grains per gallon, or 170 ppm. System will operate with hardness over 1
Page 5 Make sure the surroundings of the sink are cooled before mounting the faucet to the sink after drilling. Remove all sharp edg
Page 6 Gather and identify the faucet pieces.Remove faucet base & faucet spout from their respective plastic bags. From above the s
Page 7 Adapta Valve Installation Locate the cold water supply under the sink.Reverse Osmosis Module MountingStep 13 Determine best lo
Page 8 Non Air Gap Faucet Installation Air Gap Faucet Installation
Page 9 Thread the plastic valve onto the tank fi tting. Do not over tighten or the valve could crack.Step 17Step 18Make sure the O-Rin
Kommentare zu diesen Handbüchern